Flexplate Smooth Single Sided PEI Black

Alchemy3d Flexplate (Smooth)

This flexplate has a sheet of smooth black PEI (Mitsubishi) on one side.

What to expect

• Good adhesion with ABS, ASA and PA
• Probably good adhesion with plenty other filaments
• Sweet Mitsubishi PEI!
• Using 3M glue under the PEI 
• 0.5mm spring steel sheet - no more bending off the magnet

How to use

• Slap on your print bed, preferably with magnet - or use clips if that is your thing
• Print away!
• Use (non moisturizing) dish washing detergent to clean, rinse properly with water
• Can wipe with IPA but not with acetone!
• Give a light scrub with scotch brite ("Küchenschwamm") or brass brush if adhesion gets worse
• PETG can and likely will fuse with PEI. Use a separation layer to protect it!

Disclaimer

Picture shows 125mm variant, bigger versions due to limited size photo box not pictured.