Flexplate Smooth Single Sided PEI Black EOL

Alchemy3d Flexplate (Smooth) EOL

This Product has reached EOL and won`t be restocked again

This flexplate has a sheet of smooth black PEI (Mitsubishi) on one side.

What to expect

• Good adhesion with ABS, ASA and PA
• Probably good adhesion with plenty other filaments
• Sweet Mitsubishi PEI!
• Using 3M glue under the PEI 
• 0.5mm spring steel sheet - no more bending off the magnet

How to use

• Slap on your print bed, preferably with magnet - or use clips if that is your thing
• Print away!
• Use (non moisturizing) dish washing detergent to clean, rinse properly with water
• Can wipe with IPA but not with acetone!
• Give a light scrub with scotch brite ("Küchenschwamm") or brass brush if adhesion gets worse
• PETG can and likely will fuse with PEI. Use a separation layer to protect it!
• Some contact probes are not fully compatible with smooth PEI, please research if this is going to be an issue!

Disclaimer

Picture shows 125mm variant, bigger versions due to limited size photo box not pictured.

Product safety information (GSPR):

Productidentifier: Product Name + Variant Name
Manufacturer: Pferdmenges Simroß Alchemy3d GbR
Manufacturer Contact: Alchemy3d.de