Flexplate Satin Double Sided

Alchemy3d Flexplate (Satin)

Sick of your prints blinding you when looking at the underside?

Don't like printing on sandpaper?

We got the solution for you!

This flexplate is coated with a "satin" structure on both sides.
The texture is very fine grain (see pictures) compared to our structured sheets but is not smooth as a glass plate. Creates a nice matte finish on the print underside without hurting dimensional accuracy too much.

Migos favourite!

What to expect

• Good adhesion with ABS, ASA and PA
• Probably good adhesion with plenty other filaments
• Very fine grained structure on both sides
  
• 0.5mm spring steel sheet - no more bending off the magnet

How to use

• Slap on your print bed, preferably with magnet - or use clips if that is your thing
• Print away!
• Use (non moisturizing) dish washing detergent to clean, rinse properly with water
• Can wipe with IPA but not with acetone!
• Careful with PETG and some PC blends, adhesion might be permanent, please use a separation layer like our Bed Adhesive!

Disclaimer

• Picture shows a single variant, other versions not pictured.
• Cannot guarantee perfect adhesion with all materials